
MULTISPINDLEHEADS
From 2 to 14 Rivet-spindles
Multispindleheads are directly manufactured in our house according to our customer specifications and are therefore differenting in the riveting-points distances. From 2 to 8 rivetingspindles and a dimension up to 150mm length or round in the 0 up to 120mm are possible in the standard.
Fitting for:

BURNISHING TOOLS
Burnishing tools are perfect for the transformation of cylindrical forms and it doesn’t matter if it is the flattening down of components or if it is the widening of pipes up to a diameter of 100 mm, that is made possible with our equipment. Starting at a roll count of 3 parts, depending on the diameter, the wall strength of the work-piece should not exceed 2mm.
Fitting for:

INDEXING TABLES
With our firm clocking indexing tables with a partition of 2, 4, 5, 6, 8, 10, 12, 16, 20, or with freely programmable types we can respond to the individual requirements our customers. The speed of the tables is approximately 220 tacts/min. Special designs or the high speed variation are available on request. The work-piece holder will be customized according to request and mounted on the indexing table.
Fitting for:

PUSHING DEVICE
Manual or automatized
Our pushing device is available as the classic in the manual type with an RFID resolution according to the newest guidelines or automatized with a service unit that enables to engage different positions in longitudinal direction. The pushing device will be delivered with a protective housing against access with macrolon or with a perforated plate. The positioning of the manual type succeeds through a Short hub pneumatic cylinder that holds the position of the plate till the riveting process is finished.
Fitting for:

LOAD MEASURING PLATE
The load measuring plate is a valuable accessory for quality control, with this you can measure the rivet strength in real time on the display. Inside of it are eight risistive wire strains together with a compromised electronic. An upgrade later is also possible, our controlling are prepared after manufacture.
Fitting for:

HOLD-DOWN DEVICE
The hold-down device is used to keep the parts in position and to make sure that the riveting guarantees that the components don’t slip.
Fitting for:

WORKPIECE HOLDERS
The work-piece holders are individually manufactured together with the customer
Fitting for:

RIVETING TOOLS
Perfect for mini series and smaller riveting tasks are our tools that you can insert into any drill with MK slot. Cheap, productive, efficient, simple. Available for MK2 and MK3 slots.

WORKPLACE SYSTEMS
Ergonomics is the keyword. With our workplace systems you will also do something good for your staff as these are built according to CE standards and in combination with our riveting-machines a really strong team. Through the integrated control cabine and the high-quality housing with integrated light curtain our workplace systems become the perfect solution for automated solutions. Our workplace systems are also available in single parts and a lot of accessory is available.
Fitting for: